Open 24 Hours, Every Day (954) 203-8426  |  Book Online
Home / Blog / AC Troubleshooting
AC Troubleshooting

Why Does My AC Breaker Keep Tripping? Causes and What to Do

A breaker that trips once is a warning. One that keeps tripping is your AC telling you something is wrong. Here is what causes it and how to handle it safely.

By Cooling On Demand Inc.FL License #CAC18228486 min read
Open outdoor AC electrical disconnect box mounted beside a condenser
The outdoor disconnect and the breaker in your panel both protect the AC from electrical faults.
Quick answer

An AC breaker trips when the system pulls more electrical current than the circuit is built for. The most common causes are a dirty filter or condenser coil, a failing capacitor, a compressor struggling to start, damaged or wet wiring, or a worn-out breaker. Reset it once. If it trips again, leave it off and call a licensed technician, because forcing it can damage the compressor or create a fire risk.

In South Florida, air conditioners run almost all year, so every part works harder than in most of the country. A breaker that keeps tripping is one of the most common calls we get, and it is never something to ignore. The breaker is doing its job: shutting the power off before a problem turns into a burned motor or melted wire.

What a tripped AC breaker means

Your AC runs on a dedicated circuit, usually a double-pole breaker in your electrical panel. When the system draws more current than that breaker is rated for, or a wire shorts, the breaker snaps to the middle or Off position and cuts the power. A single trip can happen after a storm or a power surge. Repeated trips mean the system is overloaded or something has failed.

How to reset an AC breaker safely

  1. Turn the thermostat to OffThis keeps the system from restarting under load the instant power returns.
  2. Find the AC breakerIt is usually labeled AC, A/C, condenser or HVAC, and is often a double-pole breaker.
  3. Push it fully to Off, then to OnA tripped breaker sits in the middle. It has to go all the way to Off before it will reset.
  4. Wait about 30 minutesThis lets the compressor pressures settle so it does not start against a heavy load.
  5. Turn cooling back on and watchIf the breaker trips again right away or within a few hours, stop and call a technician.

Reset once, not repeatedly. Resetting a breaker over and over forces current through a fault. That can burn out the compressor, the most expensive part of your system, or overheat wiring. If you smell burning or see scorch marks on the panel, leave it off and call right away.

7 common causes of an AC breaker tripping

1

Dirty air filter

A clogged filter makes the blower and compressor work harder and pull more current. It is the first thing to check.

DIY fix
2

Dirty condenser coil

When the outdoor coil is caked with dirt, grass or salt, the compressor runs hot and draws more power. A gentle hose rinse helps.

Often DIY
3

Failing capacitor

The capacitor gives the motors their starting kick. When it weakens, the compressor strains to start and trips the breaker.

Call a pro
4

Hard-starting compressor

An aging compressor can draw a heavy surge at startup. A hard-start kit or a compressor diagnosis may be needed.

Call a pro
5

Shorted or wet wiring

Loose connections, rodent damage or water in the disconnect after a storm can short the circuit.

Call a pro
6

Failing fan motor

A seized or weak outdoor fan motor overheats and pulls extra current. You may hear humming with no fan spin.

Call a pro
7

A worn breaker

Breakers wear out too. A weak breaker can trip under a normal load. An electrician or HVAC technician can test it.

Call a pro

Storms, power surges and tripped breakers

After South Florida storms, tripped AC breakers spike. Power that drops and returns unevenly can damage capacitors, contactors and control boards, and floodwater can get into the outdoor disconnect and wiring. If your breaker started tripping after a storm, or the outdoor unit sat in water, do not keep resetting it. Book a storm and flood AC inspection, and read what to check when your AC will not work after a power outage.

Outdoor AC condenser sitting in standing floodwater beside a South Florida home
Water in the outdoor unit or disconnect is a common reason breakers trip after a storm.

A surge protector installed at the outdoor unit or the electrical panel helps protect the system from the voltage spikes that come with outages and nearby lightning. We install AC surge protection across Broward County.

DIY or call a pro?

What you noticeLikely causeWho fixes it
Trips once after a storm, then runs finePower surgeYou: reset once and monitor
Filter is gray and cloggedRestricted airflowYou: replace the filter
Trips within minutes of startingCapacitor or compressorLicensed technician
Trips immediately when resetShort circuit or wet wiringLicensed technician, right away
Burning smell or scorch marksOverheated wiringLeave it off and call now

How to keep it from happening again

  • Change your air filter every 30 to 90 days
  • Keep two feet of clear space around the outdoor unit and rinse the coil gently
  • Schedule a yearly AC tune-up, which includes testing the capacitor and electrical connections
  • Ask about a surge protector, especially if your area loses power often during storms

If the breaker trips at night when you need cooling most, our nighttime AC checklist walks through the first steps, and our AC repair team is available 24/7 across Sunrise, Weston, Plantation and Fort Lauderdale.

Good to know

Frequently Asked Questions

Is it dangerous if my AC breaker keeps tripping?

It can be. The breaker is protecting the system and your home from an electrical fault. Repeatedly resetting it can damage the compressor or overheat wiring, so reset it once and call a technician if it trips again.

Can a dirty filter make my AC breaker trip?

Yes. A clogged filter restricts airflow, which makes the system work harder and draw more current. Replace the filter first, then reset the breaker once.

Why does my AC breaker trip right after a storm?

Power surges when electricity drops and returns can damage capacitors and controls, and water can get into the outdoor disconnect or wiring. If the unit was flooded, keep it off until it is inspected.

How much does it cost to fix an AC that keeps tripping the breaker?

It depends on the cause. A filter change costs very little, while a capacitor, contactor, fan motor or compressor repair varies widely. A technician can diagnose it and give you an upfront price before any work starts.

Should I replace the breaker myself?

No. Working inside an electrical panel is dangerous. A licensed electrician or HVAC technician should test and replace a breaker if it is the problem.

Breaker Still Tripping?

Call any time, day or night. We will find the cause and fix it safely.

Book Service OnlineCall (954) 203-8426

Cooling On Demand Inc. is a Florida Certified Air Conditioning Contractor, license #CAC1822848. Read our customer reviews.

Call NowBook Online